CIREX develops complex steel components for the automotive industry and other industrial applications. These components are cast using the ‘investment casting process’ (precision casting). The casting process is high-tech, environmentally friendly and reliable. This latter characteristic is particularly vital for the automotive industry. For this specific project, Demcon was asked to automate the manual handling of measuring and bending. To achieve an accurate and reliable product within a shorter time frame, and a safe working environment for the employees.
One of the CIREX products is an injector clamp with two jaws which must be precisely aligned. With the casting process it’s not possible to achieve this parallelism within the close tolerances required. That’s why up to know, the jaws have been bent manually where needed, by pressing them against a calibre of the correct size in a press. To continue meeting the automotive quality standards with high reliability, CIREX decided to automate both the bending, and checking the bending. The company drafted in the help of Demcon because of its competence in industrial systems & vision.
The distance between the jaws are measured. Where needed they are bent further with presses, and then submitted to measurement for checking. If the distance is too small, the product will be rejected. If the distance too large, the product will be subjected to a second bending session. All this has to occur with enormous accuracy and in a short time.
The challenge was to automate the bending without a calibre repeatedly having to be inserted between the jaws. This is to keep the treatment as easy as possible, and to prevent wear. Demcon opted for a solution with vision, with the deployment of a standard smart camera from Festo. The exact orientation of the jaws could be determined with image processing. A check is performed with a virtual calibre positioned between the jaws in a 3D reconstruction of the product. Casting faults can also be detected in the 3D reconstruction.
The feasibility study for the pressing required considerable attention. Clamping the product and pressing it with a hydraulic press of 10 kN had to occur with sufficient accuracy; deviation from the nominal measurement could not be greater than ±0.1 mm. Demcon demonstrated the feasibility with a proof-of-principle arrangement. An additional task was to reduce the cycle time for the procedure, so that an approved product would emerge every six seconds. Measuring and bending has now been automated, and the next step is the automatic introduction and removal of the product. That’s right up Demcon’s street, given that it can automate entire processes.
For more information visit www.demcon.com/industrial.